- ADD NETWORK DRIVERS TO ESXI 6 WEB INSTALL
- ADD NETWORK DRIVERS TO ESXI 6 WEB DRIVER
- ADD NETWORK DRIVERS TO ESXI 6 WEB DOWNLOAD
Copy both pscp.exe and LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib into the root of an empty USB flash drive.
ADD NETWORK DRIVERS TO ESXI 6 WEB DOWNLOAD
vib file version) is needed shortly.ĭownload pscp.exe from the Download PuTTY page.
The LSI_bootbank_lsiprovider_xxx.xx.Vx.62-xxxx.vib (the x is actually a number that varies depending on the.
ADD NETWORK DRIVERS TO ESXI 6 WEB INSTALL
Next, download and install the SMI-S Provider on the ESXi machine.Īfter you have downloaded the file, unzip it and open the vib20/lsiprovider path.
ADD NETWORK DRIVERS TO ESXI 6 WEB DRIVER
You can find the VMWare driver for your Intel® RAID Controller from VMWare.
The default status of the ESXi SSH is disabled as is shown in the figure below:Īfter you verify that the requirements mentioned above are met, download and install RWC2 on the remote Windows* machine that you will use to monitor the RAID. The default status of the ESXi Shell is disabled as is shown in the figure below:. Press key to save the changes.Īfter you change the hostname, you need to enable to ESXi Shell and ESXi SSH: Press key to exit the DNS configuration. Scroll the arrow to Hostname, and then enter the new hostname. Press key to the DNS configuration screen. Current DNS configuration information is displayed on the right side of the screen. Scroll the arrow to DNS configuration. Press key to enter the network management configuration. The current hostname and IP address are displayed on the right side of the screen. Scroll the arrows to Configure Management Network. Press to enter the Customize System/View Logs. If the hostname of your machine is already different, make sure to write it down as you are going to need it later on. Verify that the hostname is not localhost. While most of the information and steps described in this article applies to RWC3, you can also refer to the RWC3 installation guide for details.Ĭonsidering that ESXi is already installed and in production, proceed as outlined below: Intel® RAID Web Console 2 is end-of-lifed and replaced by Intel RAID Web Console 3 (RWC3). You can install Intel RWC2 on a remote or virtual machine running Windows or Linux. You can use the Intel RAID Web Console 2 (RWC2) to monitor a RAID array on a VMWare ESXi server, however, it cannot be installed on ESXi directly. VMware ESXi (5.0, 5.5, 6.0, 6.5) already installed and in production. I'm unable to monitor a RAID array from a Windows Virtual Machine running in a VMware ESXi* server.
0 kommentar(er)
